Adaptive pipelining is not supported if Target Frequency is set to 0. Specify non-zero value for target frequency in Tar

Post Reply
mamorani
Posts: 8800
Joined: Thu Feb 25, 2021 6:50 pm
Contact:
Contact mamorani

Adaptive pipelining is not supported if Target Frequency is set to 0. Specify non-zero value for target frequency in Tar

Post by mamorani »

Adaptive pipelining is not supported if Target Frequency is set to 0. Specify non-zero value for target frequency in Target settings of HDL Configuration Parameters.


optimization
Top
Post Reply

Return to “Signal Processing”

Who is online

Users browsing this forum: No registered users and 12 guests