The signal at the outport of the block , port is not in a feedback loop when using the selected Open-Loop configu

Post Reply
esmatparast
Posts: 2315
Joined: Thu Feb 25, 2021 11:32 am
Contact:
Contact esmatparast

The signal at the outport of the block , port is not in a feedback loop when using the selected Open-Loop configu

Post by esmatparast »

The signal at the outport of the block , port is not in a feedback loop when using the selected Open-Loop configuration. Please select another configuration.


Control\en\compDesignTask
Top
Post Reply

Return to “Robotics System Toolbox”

Who is online

Users browsing this forum: No registered users and 8 guests