The stiffness check in auto solver is not supported for this model because the number of continuous states ' is greater

Post Reply
mamorani
Posts: 8800
Joined: Thu Feb 25, 2021 6:50 pm
Contact:
Contact mamorani

The stiffness check in auto solver is not supported for this model because the number of continuous states ' is greater

Post by mamorani »

The stiffness check in auto solver is not supported for this model because the number of continuous states ' is greater than the threshold value To change the threshold value, set the ''NumStatesForStiffnessChecking'' model parameter at the MATLAB command line
DE
Top
Post Reply

Return to “Simulink”

Who is online

Users browsing this forum: No registered users and 1 guest