Setting Zs to 0 results in NaN values for calculated Noise Figure (NF). If NF is of no interest, set Zs to a small but n

Post Reply
taghizadeh
Posts: 219
Joined: Sat Feb 27, 2021 8:43 am
Contact:
Contact taghizadeh

Setting Zs to 0 results in NaN values for calculated Noise Figure (NF). If NF is of no interest, set Zs to a small but n

Post by taghizadeh »

Setting Zs to 0 results in NaN values for calculated Noise Figure (NF). If NF is of no interest, set Zs to a small but non-zero value

analyze
Top
Post Reply

Return to “RF toolbox”

Who is online

Users browsing this forum: No registered users and 2 guests