In the "tunableTF" command, the numbers of zeros and poles must be specified as non negative integers.

Post Reply
esmatparast
Posts: 2315
Joined: Thu Feb 25, 2021 11:32 am
Contact:
Contact esmatparast

In the "tunableTF" command, the numbers of zeros and poles must be specified as non negative integers.

Post by esmatparast »

In the "tunableTF" command, the numbers of zeros and poles must be specified as non negative integers.


lftmodel
Top
Post Reply

Return to “Robotics System Toolbox”

Who is online

Users browsing this forum: No registered users and 15 guests