https://matlab1.com/forum/

The Reset Port block is only supported for HDL Code generation when in a Synchronous subsystem. To correct this issue, a

https://matlab1.com/forum/viewtopic.php?t=24278

Page 1 of 1

The Reset Port block is only supported for HDL Code generation when in a Synchronous subsystem. To correct this issue, a

Posted: Fri Mar 12, 2021 3:01 pm
by mamorani
The Reset Port block is only supported for HDL Code generation when in a Synchronous subsystem. To correct this issue, add a State Control block in Synchronous mode at or above the Reset Port block.
validate
All times are UTC
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited