https://matlab1.com/forum/

Adaptive pipelining is not supported if Target Frequency is set to 0. Specify non-zero value for target frequency in Tar

https://matlab1.com/forum/viewtopic.php?t=23450

Page 1 of 1

Adaptive pipelining is not supported if Target Frequency is set to 0. Specify non-zero value for target frequency in Tar

Posted: Thu Mar 11, 2021 12:10 pm
by mamorani
Adaptive pipelining is not supported if Target Frequency is set to 0. Specify non-zero value for target frequency in Target settings of HDL Configuration Parameters.


optimization
All times are UTC
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited