MATLAB was unable to open a pseudo-tty
Posted: Thu Jul 20, 2017 4:49 am
MATLAB was unable to open a pseudo-tty:
The unix() and ! commands will not work in this MATLAB session.
Other commands which depend upon unix() and ! will also fail.
Your system may be running low on resources.
If the problem persists after a reboot, check with your system administrator and confirm that your pty subsystem is properly configured
The unix() and ! commands will not work in this MATLAB session.
Other commands which depend upon unix() and ! will also fail.
Your system may be running low on resources.
If the problem persists after a reboot, check with your system administrator and confirm that your pty subsystem is properly configured