https://matlab1.com/forum/

The Data Source parameter specified for the Prelookup block must be set to ''Dialog'' for HDL Code generation. Breakpoin

https://matlab1.com/forum/viewtopic.php?t=24242

Page 1 of 1

The Data Source parameter specified for the Prelookup block must be set to ''Dialog'' for HDL Code generation. Breakpoin

Posted: Fri Mar 12, 2021 2:51 pm
by mamorani
The Data Source parameter specified for the Prelookup block must be set to ''Dialog'' for HDL Code generation. Breakpoint data from an input port is not supported
validate
All times are UTC
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited